Tools & Supplies
Required
Scraper
Used to remove prints from your build plate. One of these should be included with your new printer.

Precision Tweezers
Extremely handy in removing supports, especially from delicate parts.

Paper Towels
Used to clean the build plate and other resin messes.

Isopropyl Alcohol, 90% or greater
Used to wash 3D prints, clean the build plate and clean any surfaces from resin.

Highly Recommended
Silicone Scraper
Silicone scapers work great to gently mix resin in the vat and more importantly check for any failures before printing your next file!
Note: The scraper must be silicone. Other materials can scratch and damage your release film.

Filter Funnel
A filter funnel is used when pouring resin from the vat back into the bottle. It catches small, cured bits of resin that if left in the resin, could puncture the release film. Stainless steel and disposable options are available.

Hobby Knife
A hobby knife is useful for removing supports, especially if they have been partially fused to your model. Use it with caution! The sharp blade can easily remove too much material or cause injury if mishandled.

Flush Cutters
Flush cutters work great at removing large supports or support structures that have trapped or fused to parts of a model.
